MCSE习题——NT Server（8）
46.
a user at a windows 95 client computer connects to a shared printer on a
windows nt server computer that is configured as a pdc. the user reports
that she cannot access files in a shared directory on that server.
you make the user a member ofa group that has access permissions for the
directory, but she still cannot access the directory. what is the cause of
the problem?
a. the user is using an incorrect password.
b. the change you made to the user s group membership will not take effect
until the user logs off and logs on again.
c. the change you made to the user s group membership has not yet been
replicated to all of the domain controllers.
d. the user does not have an account in the domain.
47.
you configure a stripe set without parity on three physical disks. one of
the disks fails.
what can you do to recover data thatwas stored on the stripe set?
a. break the stripe set and recover the data from the remaining physical
disks.
b. install a new hard disk to replace the failed disk and choose regenerate
from the fault tolerance menu in disk administrator.
c. in the check for error dialog box in disk administrator, select fix file
system errors to recover the lost data.
d. restore the lost data from tape backup.
48.
you add a new scsi controller and network adapter to an existing windows nt
server computer. after you start the server, you receive a message that says
'the dependency service failed to start.'
where should you look for additional information about this error?
a. the bootlog.txt file
b. the device.log file
c. the services option in control panel
d. event viewer
49.
you want to perform a tape backup of the registry files of a windows nt
server computer. how must you use the windows nt backup program to do this?
a. select differential as the backup type.
b. use the windows nt backup program from a remote windows nt server
computer only.
c. specify at least one file on the volume that contains the registry.
d. stop the server service.
50.
you configure an x86-based windows nt server computer with disk mirroring
for the boot partition. the primary hard disk on this server fails.
how should you create a fault-tolerance boot disk that you can use to boot
from the mirrored partition?
a. format a floppy disk by using microsoft ms-dos.
copy ntldr, ntdetect.com, ntbootdd.sys, and boot.ini to that disk.
on the floppy disk, make no changes to the files.
b. format a floppy disk by using microsoft ms-dos.
copy ntldr, ntdetect.com, ntbootdd.sys, and boot.ini to that disk.
on the floppy disk, make changes to the arc path name in the boot.ini
file to reflect the location of the system files on the mirrored disk.
c. format a floppy disk by using windows nt.
copy ntldr, ntdetect.com, ntbootdd.sys, and boot.ini to that disk.
on the floppy disk, make no changes to the files.
d. format a floppy disk by using windows nt.
copy ntldr, ntdetect.com, ntbootdd.sys, and boot.ini to that disk.
on the floppy disk, make changes to the arc path name in the boot.ini
file to reflect the location of the system files on the mirrored disk.
51.
your windows nt server computer is configured to use nwlink ipx/spx
compatible transport. your client computer also use nwlink ipx/spx compatible
transport.
the client computers are not able to connect to the server. what is the most
likely cause of the problem?
a. the subnet mask was set to incorrectly.
b. file permission were set to no access.
c. the incorrect frame type was selected on the server.